John Bean 40HP210ES, Instruction Manual

This lift requires at least 2 persons for assembly / installation. 

1.0 SAFETY AND OPERATING INSTRUCTIONS 

When using this lift, basic safety precautions should always be followed, including the 
following: 

1.  Thoroughly read all instructions in this manual and on the lift before installing, 

operating, servicing or maintaining the lift. 

2.  Inspect lift daily. Do not operate if it malfunctions or problems have been 

encountered. 

3.  Never attempt to overload the lift. The manufacturer’s rated capacity is shown on 

the identification label. Do not override the operating controls or the warranty will 
be void. 

4.  Before driving vehicles into the lift area, position the arms to the drive-through 

position to ensure unobstructed clearance. Do not hit or run over arms as this 
could damage the lift and/or vehicle. 

5.  Only trained and authorized personnel should operate the lift. Do not allow 

customers or bystanders to operate the lift or be in the lift area. 

6.  Position the lift support pads to contact the vehicle manufacturer’s recommended 

lifting points. Raise the lift until the pads contact the vehicle. Check pads for 
secure contact with the vehicle. Check all arm restraints and ensure they are 
properly engaged. Raise the lift to the desired working height. 

7.  Some pickup trucks may require an optional truck adapter to clear running 

boards or other accessories. 

8. 

NOTE: 

Always use all 4 arms to raise and support vehicle. 

9. 

Caution! Never work under the lift unless the mechanical safety locks are 
engaged. 

10. Note that the removal or installation of some vehicle parts may cause a critical 

load shift in the center of gravity and may cause the vehicle to become unstable. 
Refer to the vehicle manufacturer’s service manual for recommended 
procedures. 

11. Always keep the lift area free of obstruction and debris. Grease and oil spills 

should always be cleaned up immediately. 

12. Never raise vehicle with passengers inside. 
13. Before lowering check area for any obstructions. 
14. Before removing the vehicle from the lift area, position the arms to the drive-thru 

position to prevent damage to the lift and or vehicle. 

15. 

Do not remove hydraulic fittings while under pressure. 

SAVE THESE INSTRUCTIONS 

2