214
9-2
9-1
Trouble shooting
9.1
System messages
The wheel balancer can show messages to the
operator. These may be error related (E-codes)
(e.g.
E
2
-
Figure 9-1
), warnings (H-codes)
(e.g.
H33
-
Figure
9-2
) or Hardware problems (X-Codes). The codes will
be described in the following chapters.
Whenever a code appears:
•
make a note of it;
•
look up the code in the list.
•
perform the steps described.
Important:
If the code is not listed here, call service team.
Errors in operation
-
Error code E
Warnings
-
Error code H
Fatal error code
-
300 or C10
9.1.1 E-Codes
E1
Rim dimensions were entered incorrectly, or
incompletely.
—
When the error code is read out, enter data once
again.
E2
Wheel guard is not closed.
E5
Range of electrical compensation exceeded
(wheel adaptor has unacceptable unbalance).
—
Press
STOP
or
ESC
–key.
—
Check wheel adaptor, repeat compensation run.
E6
The calibration weight was not fi tted for readjustment.
—
Press
STOP
or
ESC
–key.
—
Repeat readjustment.
E7
With this wheel type it is not possible to choose a
balancing mode.
—
If necessary, choose another wheel type.
..
_
..........
