16-EN
3.0-4
3.0-3
2
1
ATTENTION!
DANGER OF HAND CRUSHING
F.
Press bead seater/inflator pedal on left side of the
machine down (
1
, Fig. 3.0-3): air will come from
inflation hose end.
On model with bead seater
bS
:
G.
Press bead seater/inflator pedal on left side of the
machine half way down
(
1
, Fig. 3.0-3): air will come
from inflation hose end only.
H.
Press bead-seater pedal down swiftly to get air blast
from the inflator jets. Air simultaneously comes out of
inflator hose.
ATTENTION!
WHEN OPERATING THE bEAD SEATER
AND INFlATOR IT IS MANDATORY TO WEAR
EAR PROTECTORS AND SAFETY GlASSES
TO PREVENT CONTAMINATION FROM NOISE,
DUST AND CHIPS blOWN bY THE AIR JETS.
DANGER OF TIRE EXPlOSION
IF YOU ClAMPED THE RIM FROM THE OUTSIDE
IT MUST bE UNClAMPED WHEN INFlATING bUT
ONLY AFTER THE SRA (OPTIONAL DEVICE) IS IN
PlACE.
Presetting of clamping jaws:
N.b.:
Turntable capacity can be changed before pedal
control.
The turntable jaws can be positioned in two different
ways (Fig. 3.0-4).
Push the lever (
C
) on the left side of each jaw and shift
at the same each one (0/+4”).
VERY IMPORTANT: lOOK FOR PROPER
INSERTION OF THE PIN
CAUTION! MAKE SURE All FOUR ClAMPING
JAWS ARE MOUNTED IDENTICALLY (1 OR 2, FIG.
3.0-4). OTHERWISE THE RIM MAY COME LOOSE
AND INJURE THE OPERATOR!
Rim diameters are shown in inches on the turntable
(A, Fig. 3.0-4). The diameter setting (mark on jaw (B)
must coincide with mark on turntable) depends on the
clamping jaw position 1 or 2.
•
In jaws position 1 the diameter is preset directly (1,
Fig. 3.0-4).
•
In position 2 (2, Fig. 3.0-4) 2” must be added to the
diameter.
