LP19478 LP19479 (10/5/2018)
10
15 & 25 GALLON TOW BEHIND SPRAYER
Installation
B
A
Install Wiring Harness Extension (For
Machines With Front-Mounted Battery)
1.
Connect wiring harness extension (A) to fused harness
(B) at battery. Make sure the harness passes between
the left side hood rods.
Install Wiring Harness to Battery
B
C
A
IMPORTANT: Avoid damage! To help prevent electrical
spark, install red wire to the positive (+) battery
terminal first. Then install black wire to negative (-)
battery terminal. To prevent damage to wiring, make
sure hood does not close on wires connectors
NOTE: Depending on the location of your battery,
a wiring harness-extension may be required. Part
numbers are AM105666 (John Deere) or ST43485 -2ft,
ST43509-8ft (Superior Tech). See your John Deere
dealer to order parts.
1.
Fuse holder (A) should contain a 15 A / 32 V fuse.
Make sure fuse filament is not broken.
2.
Open hood. If battery is mounted low and behind the
grille, carefully unsnap top of grille to provide access
to battery terminals.
3.
Remove nut from positive (+) battery cable clamp.
Install red lead (B) onto clamp bolt. Install and tighten
nut completely.
4.
Remove nut from negative (-) battery cable clamp.
Install black lead (C) onto clamp bolt. Install and
tighten nut completely.
2.
Route wiring harness extension through front frame
hole.
3.
Connect extension to battery lead plug. Then snap
front grille in place.
Install Wiring Harness (For Machines With
Mid-Mounted Battery)
1.
Open hood.
NOTE: Switch (A) is not located at center of main
wiring harness. The harness plug connector nearest
to the switch gets connected to the pump leads.
2.
Connect main wiring harness to pump leads (B).
3.
Route main harness as shown and clip in place at foot
rest side panel (C). On some units route harness on
right side of fuel tank filler neck.
IMPORTANT: Avoid damage! Avoid damage to wiring.
Make sure hood does not close on wiring harnesses.
Keep wiring harnesses away from all moving parts and
hot surfaces.
4.
Connect other end of main harness to fused battery
lead (D).
5.
Close hood.
D
A
B
C
