5
SNOW BLOWER STORAGE DOLLIES
Installation
Caution: Avoid injury! Wear gloves while
installing dollies. Scraper blades may be
sharp.
Installing Dollies
1.
Lift snow blower to highest position
2.
Loosen lock knob and slide rear brace rearward.
3.
Position a dolly on each side of snowblower near
the sideplate with the front angle overlapping the
scraper bar as far as possible.
Note: When raised the snow blower dollies may
hang down.
4.
Lift dolly flush with bottom of snow blower, adjust
rear brace inward then tighten lock knob.
5.
Slowly lower snow blower to the ground, then follow
the snow blower removal instructions as normal.
6.
Ensure the snow blower is sitting level on the dollies
and roll snowblower away from tractor.
Note: Snow Blower Storage Dollies are designed to
be used on flat and level surfaces only. Take care
when maneuvering over uneven surfaces.
Adjusting Dollies
Width Adjustment
Position
Distance
A
5 3/8” - 9 5/8” (137 - 244 mm)
B
4 1/3” - 8 3/8” (105 - 212 mm)
C
2 7/8” - 7 1/3” (73 - 181 mm)
D
1 5/8” - 5 7/8” (41 - 149 mm)
D
A
C
B
Assembling Dollies
1.
Measure width of the bottom of the snowblower
(including scraper bar) and adjust dollies
accordingly. See Adjustment of Dollies.
Warning: Avoid injury! Do not allow operator
or bystanders to operate Tractor controls
while installing or removing dollies. Make
sure hands and feet are clear of snowblower
when lowering snowblower onto dollies.
