Cruisecontrol GC90 installation manual
10
Connect the “twisted pair” brown and brown/white wires in such a way
that, with the brake pedal released, one wire has +12V from the brake light
fuse and the other has ground through the brake lights.
2-pin
connector
if an original clutch switch is available, connect the violet wire
to the switching wire of the original clutch switch that switches to ground or
from ground when the clutch pedal is depressed. In this case the
green/white wire is not used. If an aftermarket clutch switch is used
connect the 2-pin connector to the clutch switch;
blue wire
connect to the vehicle speed signal wire.
Refer to the wiring diagrams of the vehicle;
yellow
wire
do not use. Cut off at 10 cm from the connector and insulate, unless
indicated otherwise;
8-pin
connector
Connect to the 8-pin connector of the CM, also refer to the installation
manual CM.
First learn the GC90 to the accelerator pedal and the speed signal, before using the
Cruisecontrol. Refer to chapter 4.0 Set-up.
i
Re-connect the negative battery terminal and remember to set the lost
volatile data (audio, board computer, clock, etcetera).