Cruisecontrol GC90 installation manual
22
6
Frequently Asked Questions
Questions
Answers
1
The cruisecontrol beeps
during the test drive or
accelerator pedal set-up.
The GC90 is not learned to the accelerator pedal
(yet). Perform the accelerator pedal set-up.
Refer to § 4.2 Accelerator pedal set-up.
2
The cruisecontrol picks up
very slowly on engaging, and
does not accelerate much.
1. The GC90 is not properly learned to the
accelerator pedal. Re-perform the accelerator
pedal set-up. Refer to § 4.2 Accelerator pedal
set-up.
2. The sensitivity is set too low. Increase the
sensitivity settings. Refer to § 4.6 Increase
sensitivity.
3
The cruisecontrol engages
during vehicle speed signal
set-up, but does not operate
during the test drive.
The cruisecontrol is not connected to a suitable
vehicle speed signal. Refer to § 3.4 Wiring
harness connections
4
The vehicle goes into limp
mode and/or the engine fault
light is ON.
One of the connectors of the T-harness was
disconnected while the ignition was switched ON
or shortly after. Reset the fault light with an OBD
scan tool according to the manufacturer’s
instruction.
