Cruisecontrol GC55 Installation manual
6
Always install the EM in a position where heat, vibration and moisture are
minimized, such as underneath the dashboard.
Undo the negative battery terminal before working on the vehicle.
Loss of volatile data is possible (audio, board computer, clock, etcetera).
Always use a multimeter when measuring on the vehicle.
Cut wires to size, keep them as short as possible.
Use a fuse of up to 10 Amps.
The servo can be installed in both engine bay to the body, and underneath
the dashboard. Never mount the servo to the engine.
Mount the servo at least 30cm from sources of electrical interference and
heat sources.
The bends in the servo cable have to be at least 40 cm in diameter.
In case a stationary switch or kick-down switch is present on the accelerator
pedal, the cable linkage should be connected directly to the accelerator
pedal.
Possible travel for the cable linkage (see pictures § 3.5.1) depending on the
chosen pulley: red pulley = 31-38mm – yellow pulley = 18-24mm.
Adjust the servo cable with a warm engine, because of a possible cold-start
device.
