John Lewis HERRINGBONE IP44 WALL LIGHT, User Manual

02

Product assembly

1

3

2

Lever open the terminal block box cover with a small 
screwdriver, pierce a hole in the black rubber 

seal

 of the 

terminal block 

and make sure this creates a tight seal 

then 

feed supply cable through. 
Make electrical connections as follows:

Fit the bulb, type and wattage as indicated on the fitting (bulb 
not supplied). The wattage indicated must not be exceeded.

To fit the shade

 (

D

)

: Offer the shade glass over the lamp 

holder section, align the treads and carefully screw into place. 
If cross-threading occurs, undo and start again. Take care not 
to over-tighten as this may cause damage to the the glass or 
the fitting.

Remove mounting bracket

 (

A

)

 from fitting by removing 

there

 re

taining screws and washers, retain for later. Using 

the mounting bracket as a template, mark and then drill 
the fixing holes in the wall (ensure the screws

 (

B

)

 are 

firmly fixed into a solid or other suitable mounting and 
not just the plasterboard.). 

Take care not to damage 

wiring.

 Attach mounting bracket to the mounting surface 

using suitable fixings. Do not attach fitting to mounting 
bracket at this stage. Make sure no wires are trapped in 
the process.

- Connect supply live to fitting live (marked “L”) on the
terminal block.
- Connect supply neutral to fitting neutral (marked

“N”) on

the terminal block.
- Connect the supply earth to the earth (marked “

”) on

the

terminal block.

NOTE: Ensure electrical connections are tight and no loose 
strands of wire are left out of the connector block. Ensure 
terminals and rubber 

seal

 are correctly seated then close 

connector block housing. Excess cable must be carefully 
located inside the wall plate or within the wall cavity itself. 
Carefully offer fitting

 (

C

)

 over mounting bracket then 

secure in place with the screws and washers removed 
earlier.

B

B

D

D

A

A

C

C