• Preform wires to the appropriate shape to
suit fitting into the mains terminal block.
• Strip inner insulation on wires using wire
strippers.
• Twist the bared wires using pliers.
• Cut bared wires 10mm away from the end
of the inner insulation. Where uninsulated
Earth wires are used ensure they are
suitably sheathed to leave 10mm bare wire
to fit into the terminal.
• Clamp bare wires into the relevant terminal
and check they are held by tugging each one
in turn.
• Clamp the mains cable securely ensuring
5mm of the outer insulation is inside the
terminal block and that the wires are not
taut but not so slack as to cause any fouling.
See diagram.
• Place fuse/miniature circuit breaker in
circuit and switch on at mains.
Checking electrical
connections
Correct electrical connection can be
confirmed when switching on the appliance as
the timer will be flashing.
Important!
House circuit Earth leakage and
continuity tests must be carried out before the
appliance is connected to the mains
Connecting to a hob or
cooker point
Either follow in general terms the instructions
for connecting to the terminal block or refer
to the hob suppliers installation instructions.
Warning!
Feed the cable through the
cabinet and arrange to route the cable
away from the appliance which may
become hot.
Fitting into the cabinet
Warning!
IMPORTANT: Ensure that
the oven is switched off at the wall
before any further work is carried out.
• Using a tape measure establish the internal
width of the cabinet. Refer to
recommended cabinet dimensions diagram
if greater than 565mm.
• Position the appliance in front of the
cabinet. Mains cable
Mains cable
• Take out all oven furniture before
installation to reduce the weight you need
to lift. The oven door should be taped up
to keep it closed whilst lifting.
45
