John Lewis JLFZW 1806, Instruction Manual

9

Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person

.

WARNING: THIS APPLIANCE MUST

BE EARTHED.

Should the appliance power supply cable

need to be replaced, this must be carried
out  by a Service Force agent (see page 1

8

).

The manufacturer declines any liability
should this safety measure not be
observed.

The appliance is supplied with a 13amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 13amp ASTA approved BS 1363/A fuse must
be used.
Should the plug need to be replaced for any reason, proceed
as described below. The wires in the mains lead are
coloured in accordance with the following code:

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

If you fit your own plug, the colours of the wires in the

mains lead of your appliance may not correspond with the

markings identifying the terminals in your plug.

Proceed as follows:

1.

Connect the Green and Yellow (earth) wire to the

terminal in the plug which is marked with the letter "E" or

the earth symbol

or coloured green and yellow.

2.

Connect the Blue (neutral) wire to the terminal in the plug

which is marked with the letter "N" or coloured black.

3

. Connect the Brown (live) wire to the terminal in the

plug which is marked with the letter "L" or coloured red.

GREEN & YELLOW

BROWN

CORD CLAMP

BLUE

13

A

P1041

E

N

L

Electrical connection

4.

Upon completion there must be no cut, or stray

strands of wire present and the cord clamp must be

secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp
socket  is a serious safety (shock)
hazard.

Ensure that the cut off plug is disposed of
safely.

The plug must still be accessible after the

appliance has been installed.

The appliance should not be connected

to the electrical supply by means of an
extension cable

Permanent connection

In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap of
3mm between the switch contacts and of a type suitable
for the required load in compliance with the current
electrical regulations.

The switch must not break the yellow and green earth
cable at any point.

Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance's
rating plate.The rating plate is located on the inside of the
appliance.