15
Owner’s Manual
L
ocation
& a
ssembLy
|
oven
assembly
C
ONTINUED
attention
The following steps should be completed in this exact order listed to prevent damage to the parts
and/or oven. A video instruction guide can be found at
1. Start with the two
Metal Support Plates.
Open the doors and set them in one at a time.
2. After the Metal support plates have been inserted place the pair of
Wide Cooking Stones
on top of
them one at a time. Make sure that the stones fit nicely within the pizza oven before moving to the next
step.
3. After placing the large cooking stones you may install the single
Top Cooking Stone
into the top center
space in the center top of the oven.
4. With all the support plates and stones installed you may now install the
Side glasses
by sliding them down into the slot holders on the left and right sides of the oven.
The
door glass
should be installed by slide the glass down into the slots on the back side of each door.
NOTE:
The door glass should only be installed after all the other internal parts have been installed to
prevent accidental damage.
5. The
Crumb Tray
should be inserted just below the front base lip of the pizza oven. Look under the front
lip to find the slot and insert the crumb tray.
6. At this point the stainless steel top cover can be reinstalled and you have completed the assembly of
your pizza oven.
assembly
parts
guide
Side Glass
Top Cooking Stone
Metal Support Plates
Crumb Tray Slot (Below base lip)
Wide Cooking Stones
1.
5.
2.
3.
4.
3.
install
internal
parts
1
1
2
2
A
A
B
B
SHEET
1
OF
1
CRUMB TRAY.dwg
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN
THIS DRAWING IS THE SOLE
PROPERTY OF SLOAN
INDUSTRIES. ANY REVIEW,
RETRANSMISSION,
DISSEMINATION, COPYING OR
OTHER USE OF OR TAKING OF ANY
ACTION IN RELIANCE UPON, THIS
INFORMATION BY PERSONS OR
ENTITIES OTHER THAN THE
INTENDED RECIPIENT IS
PROHIBITED.
UNLESS OTHERWISE SPECIFIED:
ALL DIMENSIONS ARE IN INCHES
TOLERANCES:
TWO PLACE DECIMAL: +/- .015"
THREE PLACE DECIMAL: +/- .005"
SLOAN INDUSTRIES
1439 DAVE LYLE BLVD - BUILDING 15
ROCK HILL, SC 29730
TITLE
REV
DRAWING NO.
SIZE
NAME
DATE
DRAWN BY:
APPROVED BY:
SCALE:
WEIGHT:
A
TABITHA
MATERIAL:
SURFACE AREA (IN^2):
FINISH:
Stainless
Steel
Luminous - Cream
N/A
Summary of Contents for Fuel Outdoor Pizza Oven
Page 4: ......
