- 9 -
Regulating the suction power
You can set the suction power on the device individually
as you require it using the suction regulator. We recommend using
minimum suction power for delicate materials.
Select medium suction power for mattresses, upholstered
furniture and carpets. Select maximum suction power for tiled,
wood and other robust floors.
Cleaning the exhaust air filter or HEPA filter
The exhaust air filter or HEPA filter cleans the air a final time before it leaves
the vacuum cleaner. You can clean the exhaust air filter or HEPA filter as follows:
1.
Switch off the vacuum cleaner and disconnect the plug from
the mains. To do this, always pull on the plug and not on the cable.
2.
Open the exhaust air grill.
3.
The exhaust air filter or HEPA filter is visible when the grill has been opened.
4.
Rinse the filter or HEPA filter under cold running water and allow dry.
5.
Put the exhaust air filter or HEPA filter back into place (or replace with a new one)
6.
Close the exhaust air filter grill.
•
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact you local government for information regarding the collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the
ground water and get into the food chain, damaging your health and well-being.
•
When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for
disposals at least free of charge.
An internal thermal protector has been used in your cleaner to prevent overheating as a large item or clog gets caught in the
nozzle or if the pre-motor filter becomes extremely dirty. When block is not removes, the thermal protector will trip and
cleaner will stop running. If this happens, turn the cleaner OFF and disconnect it from electrical outlet. Then disconnect nozzle
and remove obstruction. Within 30 minutes, the thermal protector will cool and automatically reset and cleaning may resume.
If cleaner does not operate, allow additional time for thermal protector to reset.
NOTE: The canister must remain unplugged during the 30 minutes cooling period.
