Johnny Vac V1 (14-10)
13
During Operation
•
Drive a path as straight as possible. Avoid bumping into the posts or scraping the sides of the machine.
Overlap the scrub paths for several centimeters (inches).
•
Avoid turning the steering wheel substantially since the machine is sensitive to steering wheel rotation.
Avoid sudden turning unless emergency.
•
Please do scrubbing from the bottom when the machine reaches to the bottom of passage.
•
Adjust machine speed and water flow as needed during scrubbing. Keep driving at a moderate speed
with minimum water flow.
•
Keep the machine running to avoid damages to the ground.
•
If poor scrubbing performance is observed, stop scrubbing and refer to troubleshooting.
Scrubbing method
•
Pour a recommended foam control solution into recovery tank if excessive foam occurs. Otherwise the
vacuum motor may be damaged if the foam is sucked into the motor.
•
Change the pad holder or cleaning pad as necessary for better scrubbing performance.
•
Observe the battery indicator to ensure there is adequate power for machine to operate.
•
Observe the solution tank indicator to ensure the solution does not run out. Please clean the tank
before refilling.
•
Remove the key when leave the machine unattended.
•
Perform daily maintenance after scrubbing (see Maintenance).
•
Drive the machine slowly on inclines: press brake pedal to control the machine and turn down speed
switch when driving down. Do scrubbing when machine goes upward instead of downward.
FOR SAFETY
:
•
Drive slowly when using machine on inclines or smooth surfaces.
•
Do not operate the machine in areas where the temperature exceeds 43
o
C(110°F). Scrubbing function
cannot be used in areas where the temperature is lower than 0
o
C (32°F).
•
Maximum rated slope is 7% during operation. Maximum rated inclination for transporting the machine
is 19.25%.