SQUEEGEE BLADE ADJUSTMENT
Squeegee blade has been tuned before delivery. It needs adjustment only when its position
deviates.
To obtain optimal effect, squeegee assembly caster must be adjusted to a certain height and
inclination following the instructions below.
1. Check whether squeegee blade totally contacts, make sure the distance between wheel and
ground is about 2 mm. After then squeegee is adjusted properly, squeegee blade should bend as is
shown in the follows during machine operation.
2. Adjust the regulating nut as indicated by arrow 2 in the following diagram if squeegee blade does
not contact the ground or there is a small gap between them. Clockwise rotate the regulating nut to
lift the squeegee blade; anticlockwise rotate the regulating nut to lower the squeegee blade. Adjust
the squeegee blade to an optimal status according to actual demands (Figure 35).
- 30 -
User Guide
JVC85BCT
M A C H I N E M A I N T E N A N C E
Figure 34
Figure 35