Air Pen Drive Instructions for Use DePuy Synthes 11
Attachments
General Information
Mounting the attachments on the handpiece
The attachments can be connected in 8 different posi-
tions (45° increments). To mount, turn the release sleeve
for the attachments clockwise (see arrow on the release
sleeve) until it engages. The release sleeve protrudes
slightly from the black section of the handpiece towards
the front. Insert the attachment into the attachment
coupling from the front and press it lightly against the
handpiece. The attachment automatically engages. If the
release sleeve accidentally closes, turn the attachment
clockwise while applying slight pressure against the
handpiece until it engages without holding the release
sleeve in place, or repeat the entire connection process.
Check secure holding of the attachment on the hand-
piece by pulling on the attachment.
Removing the attachments from the handpiece
Turn the release sleeve for attachments (see page 6)
clockwise until it disengages. Hold the attachment up-
ward while doing so. Then remove the attachment.
Attachments and accessories
For easier change of burrs, without having the Burr
Attachment or Cranio tome Attachment connected to
the handpiece, the Handhold for Change of Instruments
(05.001.074) can be used.
Warranty:
Only use Synthes saw blades, burrs and
rasps while working with the Air Pen Drive
attachments. The use of other tools voids the device
warranty.
Release sleeve
