1
1
Air Pen Drive Instructions for Use DePuy Synthes 19
Drill/Burr Attachment, Straight,
for Round Shafts
B
2.35 mm (05.001.123)
Gear ratio 1:1
Drill/Burr Attachment, Straight,
for Round Shafts
B
2.35 mm (05.001.128)
Gear ratio 16:1
Friction fit attachment for 2.35 mm diameter shafts with
round shaft, J-latch and Mini-quick coupling.
Changing cutting tools
1. Lock unit.
2. Turn the release sleeve (
1
) until it engages in the
UNLOCK position and remove the tool.
3. Insert the new tool and turn the release sleeve into
the LOCK position until it engages.
Precautions:
•
The user is liable for the safety and correct appli-
cation of the Synthes Power Tool including the
attachment and the cutting tools. In particular
consider the following points:
•
maximum speed of the Drill/Burr Attachment
for round shafts with 2.35
mm diameter is
60,000 rpm for 05.001.123 and 3,750 rpm for
05.001.128.
•
the use of appropriate cutting tools (specifically
length and speed)
•
the secure fixation of the cutting tool, i.e. the tool
must be fully inserted
•
the instrument must be rotating before contact is
made with the workpiece
•
avoid jamming and using the instrument as a lever
as this leads to an increased risk of breakage
•
Check the vibration and the stability of the used
cutting tool before every usage on the patient.
If vibration or instability occur, reduce the speed
until there is no vibration anymore or do not use
the burr.
