DINAMAP*
Compact
Vital Signs Monitor
6
3.2.2 The Service Menu (Service mode 2 2 1 3) 30
3.3 Calibration - Checking & Re-calibrating 34
3.3.1 Checking of NIBP Calibration 34
3.3.2 NIBP Calibration 35
3.3.3 NIBP Pop Off Checking 36
3.3.4 NIBP Pop Off Pressure Calibration 37
3.3.5 Predictive Temperature Calibration Check 38
3.3.6 Predictive Temperature Calibration 39
3.4 Monitor Disassembly 41
3.4.1 Removal of the Front Panel 41
3.4.2 Removal of the Switch board, Display board and Liquid Crystal Display module 43
3.4.3 Removal of the Chassis 44
3.4.4 Removal of the Main Board and Power Supply board from the chassis 45
3.4.5 Removal of the Pump and Pressure Transducer 47
3.4.6 Removal of the Printer 48
3.4.7 Reassembling the Monitor 49
4 MANUAL RELEASE TEST PROCEDURE 50
4.1 General 50
4.1.1 Test Equipment 50
4.1.2 Test Conditions 50
4.1.3 Service mode 50
4.2 Test Procedure 51
4.2.1 Power Up Tests 51
4.2.2 External DC Supply and Battery Indication Operation 51
4.2.3 Temperature Requirements 51
4.2.4 Pulse Oximeter Requirements 52
4.2.5 NIBP Requirements 53
4.2.6 Printer Operation 54
4.2.7 Calibration Time Stamp 54
4.3 Manual Release Test Results Sheets 56
5 TROUBLE SHOOTING. 58
6 TECHNICAL INFORMATION 64
6.1 Host Port Connector (rear panel) 64
6.2 Remote Alarm Connector (rear panel) 64
6.3 Accessory Part Numbers 65
6.4 DINAMAP*
Compact
Service Spares List 66
6.5 Procedural & Error Alarm Code Table 72
7 GLOSSARY OF TERMS AND ABBREVIATIONS 74
8 SERVICE DIAGRAMS 75
