Installing the display
The display can be permanently mounted on a
panel or on the wall. For panel or wall mounting
applications, the display unit is permanently
connected to at least one controller.
This chapter describes how to:
•
Mount the display on a wall or panel located
in a remote location from the unit
•
Cable the display for a single controller
application
•
Cable the display for a multiple controller
application
When the display is selected while ordering the unit
through the Selection Navigator tool, the factory
mounts the display on the unit control panel in the
controls section.
Note:
The standard UI is installed in the unit
control panel as a default if the touchscreen
display was not selected when ordering the
unit. If the standard interface must be replaced
with the touchscreen display in the field,
contact the factory for further information.
Key concepts
Mounting options
Mount the display remote in an existing control
panel or on a wall, using a BOX710-01 display
enclosure from Johnson Controls, shown in Figure 2.
Display unit dimensions
Figure 3 shows the overall dimensions of the
display. For panel cutout dimensions or wall
enclosure drill hole spacing, see
Internal components of the display
Figure shows the rear view of the display with all
ports for communication, storage, and power.
Figure 2: BOX710-01 Display enclosure for wall
mount
Figure 3: Display unit dimensions
Table 1: Display unit dimensions
Item
A
B
C
H
L
Display (in./mm)
10.66 / 271
10.66 / 271
2.20 / 56
7.75 / 197
11.10 / 282
Note:
A and B represent dimensions for cutout.
Advanced Graphic Touchscreen Display on 25 Ton to 80 Ton Johnson Controls Premier Rooftop Units
8
Johnson Controls
