34
P5417050-rev.1
•
This “Individual Louver Setting” is NOT available when two wired controllers are used in the same
H-LINK. (This includes the combination with the wired controller and the wireless controller.)
•
The individual louver setting is available for up to 16 indoor units using a single wired controller.
4. Select the indoor unit to change the louver direction by
pressing “ ” and press “OK”.
(This screen is NOT displayed when only one indoor
unit is connected to the wired controller. In this case,
move to Step 5.)
5. Press “ ” and select the louver direction.
The selected louver is opened and the other louvers are
closed.
6. Press “Menu” while “Back/Help” is pressed.
The confirmation screen is displayed.
7. Select “Yes” and press “OK”. Screen of Step 5 (above)
is displayed after the setting change is confirmed.
If “No” is selected and “OK” is pressed, the screen
returns to Step 5 (above).
▫ Regarding the “Individual Louver Setting”, the louver
selected at Step 5 (above) is set as “Number 1” and
the other louver numbers are change clockwise
automatically as shown at the right.
OK
Individual Louver Setting
01-01
01-02
01-03
Select unit to set.
01-04
Entr
Rtrn
Sel.
Back
2
1
Individual Louver Setting:01-03
Adjust air direction & louver angle.
Sel.
Adj.
OK
Entr
Rtrn
Back
Change louver outlet number?
(2 1, 1 2)
Louver Outlet Setting:01-03
Yes
No
Sel.
Entr
Rtrn
OK
Back
8.10 Control of Dew Condensation Prevention
This function limits the occurrence of condensation around louvers. Condensation can occur when the air
conditioner has run in cooling mode over a prolonged period of time at 86
o
F DB (30
o
C DB) and a high rate
of humidity (relative humidity: approximately 80%). If there is any anticipation of upcoming operation under
these conditions, set optional function K8 to "01" on the function selection menu to safeguard against
condensation. Refer to the "Installation and Maintenance Manual" of wired controller for details.
3. Select “Individual Louver Setting” from the Individual
Louver Setting screen and press “OK”.
OK
Cancel INDV Louver SET
Individual Louver Setting
Individual Louver Setting
Entr
Rtrn
Sel.
Back