DRCPX Remote Controller User Manual
4
•
When selecting fan mode, just the air conditioning fan will blow, no cooling or heating.
Press the FAN button to adjust the fan speed. Press the SWING button to adjust the
louver angle of the fan.
•
Select Heat mode and the air conditioner will operate under this mode. The heat
indicator on the indoor unit turns ON.
o
Press the UP or DOWN button to adjust the set temperature.
o
Press the FAN button to adjust the fan speed.
o
Press the SWING button to louver angle of the fan. (A cooling-only unit will not
receive the Heat mode signal.) If setting the Heat mode with the remote
controller, pressing the ON/OFF button will not start the unit.
Note:
You can prevent cold air from blowing after starting up in heating mode.
The indoor unit will delay 1~5 minutes before blowing air. (The actual delay time
depends on the indoor ambient temperature.)
Set the temperature range from the remote controller to: 61~86°F (16~30°C).
Set the Fan speed to: auto, low, medium, or high.
FAN Button
Press Fan button to set fan speed to auto (AUTO), low ( ), medium ( ), or high( ).
•
Under AUTO speed, the air conditioner selects the proper fan speed automatically
according to the default factory setting.
•
The Dry mode Fan speed is low.
SWING button
Press this button to select the up-and-down louver angle. The angle that the fan blows can be
selected clockwise as follows:
no display
(Horizontal louver stops
at the current position.)
•
When selecting
, the air conditioner fan blows automatically. The horizontal louver
will automatically swing up and down at a maximum angle.
•
When selecting
, the air conditioning fan blows in a fixed position
only. The horizontal louver will stop moving at the fixed position.
Hold
button for 2 s to set the louver angle. When you reach the angle you want,
Auto
