Network Room Module Technical Bulletin
15
Installing and Commissioning the
Network Room Module
Introduction
The Network Room Module is designed to mount directly on a wall
surface in the room you want to control. Separate kits are also available
for wall surface mounting with conduits and recessed wall box mounting
(see Ordering Codes). The wiring enters the module from the back.
IMPORTANT:
Use this Network Room Module only as an operating control.
Where failure or malfunction of the NRM could lead to personal injury or property
damage to the controlled equipment or other property, additional precautions
must be designed into the control system. Incorporate and maintain other
devices, such as supervisory or alarm systems or safety or limit controls,
intended to warn of or protect against failure or malfunction of the NRM.
North American Emissions Compliance
United States
This equipment has been tested and found to comply with the limits for a
Class A digital device pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when this equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy, and if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at his/her
own expense.
Canada
This Class (A) digital apparatus meets all the requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la Classe (A) respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
