FX-WRZRMT10K-0 Wireless Remote Temperature Transmitter Installation Guide
2
North American Emissions Compliance
United States
Canada
Installation
Follow these guidelines when installing the
FX-WRZRMT10K-0 Wireless Remote Temperature
Transmitter and the associated TE-6300 Series
Temperature Sensor:
•
Transport the transmitter and sensor in their
original containers to minimize vibration and shock
damage.
•
Verify that all the parts shipped with the transmitter
and sensor.
•
Do not drop the transmitter or sensor, or subject
either component to physical shock.
•
Do not attempt to remove or repair the circuit board
from the transmitter housing. Other than battery
replacement, the transmitter and sensor are not
user serviceable.
Parts Included
•
FX-WRZRMT10K-0 Wireless Remote Temperature
Transmitter (includes one transmitter, one
mounting base, and strips of double
-
sided
adhesive foam tape; all factory assembled)
•
one strain relief bushing
•
one DIP switch overlay for a mesh network
application using an FX-ZFR1811 Router
•
one DIP switch overlay for a non-mesh network,
One-to-One application using an FX-WRZ7850-0
Receiver
•
one installation instructions sheet
•
two AA alkaline batteries
Dimensions
See Figure 1 for dimensions and physical features of
the FX-WRZRMT10K-0 Wireless Remote Temperature
Transmitter and the associated TE-6300 Series
Temperature Sensor.
Special Tools Needed
•
1/16 in. (1.6 mm) Allen
-
head adjustment tool
(Johnson Controls T-4000-119; order separately)
for the tamper-resistant set screw that secures the
transmitter to the mounting base
•
1/8 in. (3 mm) blade screwdriver for making wiring
connections to the terminal block on the transmitter
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference
received, including interference that may cause
undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
Industry Canada Statement
The term
IC
before the certification/registration
number only signifies that the Industry Canada
technical specifications were met.
Le terme « IC » précédant le numéro d'accréditation/
inscription signifie simplement que le produit est
conforme aux spécifications techniques d'Industry
Canada.
Figure 1: FX-WRZRMT10K-0 and TE-6300
Dimensions and Physical Features, in./mm
Signal
Test Button
Tamper Resistant
Set Screw
4-23/32
120
1-1/2
38
°F/°C
Button
FI
G
:dm
ns
ns
3-5/32
80
10 ft (3 m)
Plenum-Rated Cable
3
76
1/4 in. (6 mm)
Outside Diameter
Back of Base
to Front of
Protrusion
