Johnson Controls FX-WRZRMT10K-0, Installation Manual

FX-WRZRMT10K-0 Wireless Remote Temperature Transmitter Installation Guide

4

3. Peel off the protective paper from one side of the 

factory-installed strips of adhesive foam tape on 
the back of the mounting base.

4. When positioned correctly, the arrow between the 

terminal slots on the inside of the mounting base 
should point up. Ensure that the mounting base is 
upright (tamper-resistant set screw on top) and 
press the base firmly onto the clean mounting 
surface.

5. See 

Connecting the TE-6300 Series Temperature 

Sensor to the FX-WRZRMT10K-0 Wireless 
Remote Temperature Transmitter

.

Removing a Mounting Base Installed with 
Double-Sided Adhesive Foam Tape

To remove or relocate a transmitter mounted with 
double-sided adhesive foam tape:

1. Remove the transmitter housing from its mounting 

base (Figure 2). 

2. Remove the mounting base from the mounting 

surface by carefully twisting the base off of the 
surface.

3. Remove the adhesive foam tape from the mounting 

base and clean the mounting base to remove any 
leftover adhesive.

Note:

New double-sided adhesive foam tape is 

required to remount the base on the surface; use 
Can

-

Do National Tape (Code No. 99116) adhesive 

foam tape or its equivalent.

Connecting the TE-6300 Series Temperature 
Sensor to the FX-WRZRMT10K-0 Wireless 
Remote Temperature Transmitter

To connect the TE-6300 Series Temperature Sensor to 
the FX-WRZRMT10K-0 Wireless Remote Temperature 
Transmitter:

1. Feed the wire lead through the hole on the bottom 

edge of the transmitter housing.

2. Loop the wire lead through the strain relief bushing 

(included with the transmitter) as shown in 
Figure 3, just inside the bottom edge of the 
transmitter housing.

Note:

The strain relief bushing is designed to 

accommodate wire sizes ranging from 1/16 to 3/16 in. 
(2 to 5 mm) in diameter.  

Figure 3:  Looping the Wire Lead through the 

Strain Relief Bushing

1

2

3

4

FI

G

:st

rn

_rl

f_bs

hn

g