Installation Instructions
LC-203/BLC-203 and LC-204/BLC-204
3
ISTISJCEBLC2034 0.0
LC-203/BLC-203/LC-204/BLC-204 complies with requirements EN 50131-2-4 Grade 2 (grade 3 for LC-203/BLC-203), EN 50131-
2-4 Class II
Hereby,
Tyco Safety Product Canada Ltd.
declares that the radio equipment type
LC-203/LC-204
is in compliance with Directive 2014/53/EU. The full text of the EU declaration
of conformity is available at the following Internet address:
LC-203
, h
ttp://dsc.com/pdf/2210001
;
LC-204
,
http://dsc.com/pdf/2210002
.
Hereby,
Johnson Controls Products Italia S.r.l.
declares that the radio equipment type
BLC-203/BLC-204
is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following Internet address:
www.bentelsecurity.com/dc
.
Installation must be carried out by trained personnel according to professional standards.
The manufacturer accepts no responsibility if the product is tampered with by unauthorized persons.
The alarm system should be checked for proper operation at least once a month. However, a reliable electronic alarm system does not prevent intrusion, robbery, fire or anything else
but merely decreases the risk of such situations occurring.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
– Consult the dealer or an experienced radio/TV technician for help.
Warning!
Changes or modifications to this equipment not expressly approved by the party responsible for compliance (Tyco Safety Products Canada Ltd.) could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC rules. Operations are subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must
accept any interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numrique de la classe B est conforme a la norme NMB-003 du Canada.
© 2022 Johnson Controls. All rights reserved. JOHNSON CONTROLS is a registered trademark. Unauthorized use is strictly prohibited.
