TE-6800 Series Temperature Sensors Installation Instructions
7
Repair Information
Do not field repair the TE-6800 temperature sensors.
As with any electrical device, keep the air vents clean
and free from dust or obstruction. If the TE-6800
temperature sensor fails to operate within its
specifications, replace the unit. For a replacement
sensor, contact the nearest Johnson Controls
representative.
Technical Specifications
TE-6800 Series Temperature Sensors
Nickel Sensor
Temperature Sensor
1000 ohm thin-film nickel
Temperature Coefficient
Approximately 3 ohms per F° (5.4 ohms per C°)
Reference Resistance
1000 ohms at 70°F (21°C)
Accuracy
±0.34F° at 70°F (±0.18C° at 21°C)
Platinum Sensor
Temperature Sensor
1000 ohm thin-film platinum
Temperature Coefficient
Approximately 2 ohms per F° (3.9 ohms per C°)
Reference Resistance
1000 ohms at 32°F (0°C)
Accuracy
±0.35F° at 70°F (±0.19C° at 21°C)
Setpoint Range
Single Adjustment
Warmer/cooler
Sensor
Response Time
10 minutes at 10 feet per minute
Field
Connections
Modular Jack
8-position modular jack connector
Terminal Block
Screw type terminals for 18 to 24 AWG wire
Zone Bus
Access
6-pin connector with front bottom access for a laptop with HVAC PRO software and CVTPRO converter
Manual Override
Integral momentary push button (DIP switch selectable)
LED Light
Green
LED light indicates two modes of operation (VMA1200 and VMA1400 Series controllers only)
Ambient
Operating
Conditions
32 to 131°F (0 to 55°C)
10 to 95% RH, noncondensing; 86°F (30°C) maximum dew point
Ambient
Storage
Conditions
-40 to 140°F (-40 to 60°C)
5 to 95% RH, noncondensing; 86°F (30°C) maximum dew point
Materials
White thermoplastic
Accessory
NS-WALLPLATE-0
Adapts a TE-6800 Sensor (80 x 80 mm) to a standard 80 x 120 mm
wallbox
Dimensions
(H x W x D)
3-1/4 x 3-1/4 x 1-7/16 in. (80 x 80 x 36 mm)
Shipping Weight
1 lb (0.5 kg)
Compliance
United States
UL Listed, File E107041,
CCN PAZX, Under UL 916, Energy Management Equipment
Canada
UL Listed, File E107041,
CCN PAZX7, Under CAN/CSA C22.2 No. 205, Signal Equipment
Europe
CE Mark – Johnson Controls, Inc. declares that the TE-6800 Series
Temperature Sensors are in compliance with the essential requirements
and other relevant provisions of the EMC Directive
Australia and New Zealand
RCM Mark, Australia/NZ Emissions Compliant
