johNSoN coNtroLS
1-4
ForM 102.20-N1 (1109)
Pre-installation
StORAgE
Short-term Storage
Indoor Units:
Under no circumstances should out-
door storage be used
Outdoor Units:
Be sure all shipping covers are re-
applied after inspection, or tarps are
used during storage.
Short-term storage is considered six (6) months or less
from date of shipment. Storage maintenance during
this time is usually limited to the following.
• Rotate fans every four (4) weeks beginning upon
arrival to prevent moisture from damaging bear-
ing.
• If the units are to be stored out-of-doors, prior to
installation, special care must be taken to cover
and protect the units from dust, rain, snow and
rodents. The units must be protected from con-
stant exposure to rain and snow.
• Store on a firm, flat surface to prevent distortion.
Block the unit off the ground to protect compo-
nents from water.
Protect all parts and porous materials
from rain and other sources of mois-
ture. Decontaminate or replace as
needed to ensure microbial growth is
not introduced to the air handler.
• The unit must also be protected from damage to
the exterior of the cabinet or coil connections by
construction vehicles and personnel.
IAQ
inSPECtiOn
Check For damage
Receiver Responsibility
Receiver is solely responsible for noting freight bill and
filling freight claims IMMEDIATLY
(see “Receiving”
in this section).
Visible damage should be noted on the signed and
dated bill of lading with a request that the carrier
inspect the damage within 72 HRS. of notification. The
shipping wrapper must be removed and replaced with
a tarp or similar protective covering. Any concealed
damaged reported after 15 days will compromise a
claim settlement. Inspection requests may be done
by telephone or in person, but should be confirmed in
writing. If assistance is needed with the claim process,
contact your Johnson Controls Sales representative.
Indoor Units
It is Johnson Controls intention that a shipping wrapper
be applied to unpainted indoor units for protection
from weather, road dirt, etc. during inland transit and
that the wrapper be removed at the time of delivery to
allow for a thorough inspection, both inside and out.
Outdoor Units
Outdoor units are not fully wrapped. Exposed openings
are covered for protection from weather, road dirt, etc.
during inland transit. A thorough inspection, both
inside and out, should be done at the time of delivery.
Checking for non Mounted Parts
•
Check the packing list for non-mounted ship
loose parts. (Check inside all segments.)
•
Packing list will note how many and type of
parts.
•
Shortages must be reported within 10 days after
receipt of order.
See Ship Loose Parts, Fig 2-8 thru 2-14.
Summary of Contents for YORK SOLUTION LD09624
