3
johNSoN coNtroLS
ForM 102.20-N1 (1109)
In complying with Johnson Controls policy for
continuous product improvement, the information
contained in this document is subject to change
without notice. While Johnson Controls makes no
commitment to update or provide current information
automatically to the manual owner, that information, if
applicable, can be obtained by contacting the nearest
Johnson Controls Service office.
ChAngEABilitY OF thiS dOCuMEnt
It is the responsibility of operating/service personnel
to verify the applicability of these documents to the
equipment in question. If there is any question in
the mind of operating/service personnel as to the
applicability of these documents, then prior to working
on the equipment, they should verify with the owner
whether the equipment has been modified and if current
literature is available.
NOTICE TO CUSTOMER/CONTRACTOR
PROTECT yOUR WARRANTy PRIOR TO
STARTUP.
• Read and follow the Installation and Start-up
Instructions provided with this equipment.
• Storage of this equipment
MUST
be on a flat
surface and protected from the weather.
• Protect this equipment from damage, construction
dirt, debris and water.
DO NOT OPERATE DOORS WHEN UNIT
IS NOT ON A FLAT SURFACE.
• Isolate this equipment from pressure testing of
water, steam, gas and air piping.
• Do not test, clean and flush piping through coils
in this equipment.
• Isolate this equipment from temporary building
power.
• Contact local Johnson Controls Service for pur
-
chase of Startup Service with two weeks advance
notice. Provide current job site contact.
• To perform a careful and thorough startup, verify
the following:
– Reliable power will be available for
startup.
– Ductwork is complete.
– Controls are complete.
– Shipping splits completely re-assembled,
sealed and wired.
– Filters are installed and secured.
– All shipping materials have been removed.
METAl TAB USED TO SECURE
DOOR IS A SAFETy DEVICE. DO
NOT DISCARD IT.
– Start-up will be performed according to that
outlined in Section 3 of the Installation and
Start-up Instructions provided.
• Temporary use of air handler requires startup
performed according to that outlined in Section
3 of the Installation and Start-up Instructions
provided.
• A qualified startup technician must complete
the
“AIR HANDLING UNITS START-UP
CHECK LIST”
Form 100.00-CL1 and file a
copy at the local YORK Service Office. This
form is provided in the information package with
each air handler.
• Rotate fans every four (4) weeks beginning upon
arrival.
Summary of Contents for YORK SOLUTION LD09624
