9
Window displayer
1.
Speed:
Display the present speed
2.
Time:
Display the time of manual mode or count backward time under the program and
mode
3.
Distance:
Display the accumulative distance under the manual and program mode or count
backwards distance of the mode working
4.
Calorie:
Display the accumulative calories under the manual and program mode or count
backwards calories of the mode working
5.
Heart rate:
detected heart rate, the heart mark flashing, and display pulse value.
Quick and short cut keys
1. Quick Key is illustrated on the panel:
Quick speed “3,6,9”, Quick incline “3,6,9”
“Prog”, “Mode”, “
，
Incline-”, “Speed + ”, “Speed - ”,
2. Shortcut key for handlebar:
“Speed + ”, “Speed - ”,“”, “Incline-”
Parameter
Voltage
AC:220~240V 60Hz
Max load
110Kg
Running area
420*1250
Max power
1.75HPP
Speed Display
1.0
～
14.0Km/h
Safety
Remove the Safety key, the treadmill will stop slowly. The console will stop working. Also an
intermittent beep will occur and the console will show”---”
Program & Mode
Turn on the power and attach the safety key before entering the modes.
1. Manual mode
A. Attached the safety key, Press the ”Start” button, buzzer sounds bi-bi-bi and speed window
countdown from 3 to 1,then treadmill will start run.
B. Treadmill will record the parameter and window will refresh showing the current dates,
C. Shortcut key for speed can adjust the exact speed
D. Press the “stop” button, treadmill will stop slowly.
E. When the running time over 99:59 minutes, treadmill do not stop, time will clear and will re-
start from zero.
2. “Mode”:
A. Press “Mode” key, the window will start blinking to advise you to select the mode being
“ time ,distance, calories”, adjust the setting by the key “speed +” & “speed - ”,press “start”
key to enter the mode and treadmill will start to run.
B. Treadmill will record the parameter and window will refresh showing the current data,
C. Press the “stop” button, treadmill will stop slowly.
D. Treadmill stop running and display will show “END” when the training exercise reach to your
setting value.
3. “Prog.”:
