CHAPTER 6: Part Replacement Guide
28
6.4
RUNNING DECK REPLACEMENT
1) Remove the motor cover as outlined in Section 4.1.
2) Remove the side rail as outlined in Section 4.3.
3) Remove the end cap in section 4.2
4) Remove the running deck screws (Fig-1).
Fig-1
Fig-2
5) Remove the running deck from the running belt
6) Reverse Steps 1-4 to install a new running deck. (Fig-1 & Fig-2)
7) The running deck is silicon on desk. New deck surfaces must ALWAYS be matched to a new running) not
Slip.
8) Adjust the tension after replace new running deck. (Section 4.6, Note)
Summary of Contents for AFG 5.5AT
