15
Coffee Grinder
Place the coffee grinder ( M ) on the base
( H ) at the notches , then turn it slightly
counterclockwise until it stops ( Fig . 1 )
.
Suggestions
To avoid spillages, never fili the container
aver two thirds of its capacity.
The liquid ingredients (far example oil)
can
be poured into the jug while the appliance
is on through the opening (C) in the lid (D)
by temporarily removing the plug (B).
Pre-cut solid ingredients into smaller pie
ces (around 1-2 cm) before placing them
in the blender. For best results, do not
piace large quantities of ingredients at
a time in the jug, but rather insert small
quantities at a time.
Never piace your hands or other objects in
the container while the blender is working.
lf part ofthe food being processed remains
on the sides of the jug, detach it and push
it towards the biade using the mixer (A).
Attention:
Do not remove the jug before the blender
has completely stopped.
Use the blender only with the jug correctly
filled.
Cleaning
Cleaning the appliance and its parts is
easy if carried aut after each use.
Never clean the accessories or parts of the
appliance in the dishwasher.
Clean the motor unit with a damp cloth.
Never use abrasives, metal cleaning pads,
alcohol, etc.
Disconnect the appliance, dismantle the
accessories and the used parts and clean
with lukewarm water and detergent.
Rinse ali the accessories and parts under
the tap.
Never piace the motor unit in water or ano
ther type of liquid,never rinse under a tap.
Use a damp cloth on the motor unit.
The parts of the appliance could have co
lour transfer if strongly pigmented food is
used. This is normal.
After use and having cleaned and dried
the appliance, to make it more compact
wind the power supply cable around the
“cable winder” (L) found at the bottom
of the motor unit (H).