![background image](http://html1.mh-extra.com/html/johnson/c7000/c7000_service-manual_2022576032.webp)
extractor
Coin
(14&17 mm)
1.
ove
the side
driver, then
remove footpad, guard and side cover.
2.
f idler
ous.
you and other parts)
, then
remove the front pulley.
3.
the pulley and replace with the new 500(440)J8 belt
.
Reverse step 1-3 to install the parts.
POLY V BELT 500/440 J8 REPLACEMENT PROCEDURE
Tools required:
Philips
screwdriver
Hex key
(4mm)
Open end
wrench
(14mm)
Crank
Open-end
wrench
Procedure:
Remove the crank cover
and screw, then rem
the crank.
(Refer to
section 5-2.1)
. Loosen
the screws from
cover with the
screw
Loosen the screws from
the front pulley by using
the hex key (4mm) and
the fit-in screw o
spring by using
screwdriver (
The spring
replacement is danger
Take special cautions
during the operation
so
you will not damage both
Remove the 500(440 for JPB-5100) J8 belts from
4
Summary of Contents for C7000
