No pulse display on the console (Hand pulse type)
Possible causes:
1.
Connection of hand
pulse cable.
2.
Hand pulse cable is
damaged.
3.
Console is damaged.
Procedure:
1.
Remove the console to check if the terminal of hand
pulse cable has been connected to PCB well.
OR
2.
Replace the hand pulse cable with a new one.
OR
3.
Replace the console with a new one
4-7
Summary of Contents for E7000
