18
OPERATING INSTRUCTIONS
Components
A. Appliance shell
B. Blades
C. Hair guides for cutting adjustment
D. ON/OFF switch
E. Light
F. Adapterforpowersupplyunit
G. Adapter plug
H. Small lower plug cable of the appliance
I. Numeric indicator spacer
L. Small cable socket
M. Recharging base
N. Small upper socket of the recharging
support
O. Small lower plug of the appliance
P. Small back plug of the recharging base
Q. Comb
R. Small brush
S. Container for lubricant
T. Cutting spacer from 4 mm to 18 mm
Z. Hook for spacers
Operation:
As it is easy to use, the appliance is suita-
ble to be used at home for beard and hair
trimming.
Its ergonomic and elegant shape makes it
particularly handy.
It is possible to obtain the shortest cutting
size by not assembling any spacer on it. If
you wish to use a spacer (T), hook it on the
Z pivots of the appliance (fig. 5) and adjust
the distance of the blades by means of the
guide C (fig. 6).
Cutting adjustment size
Fig.1 The appliance can be used either
connected to a mains socket or in cordless
mode, owing to the incorporated battery.
The use of the battery allows to use it wi-
thout length and space requirement limits
of the cable.
Battery charge (Fig.2 and Fig.3)
Place the appliance A on the plug N of the
recharging base M. Insert the small cable
socket L on the small back plug P, then
in- sert the plug G of the adapter in a su-
itable mains socket, (the E light turns on)
and the battery starts charging.
Use of the appliance
with the incorporated battery
Choose the cutting size according to in-
structions of fig. 6. Grab the shell of the
appliance A, push the D switch upwards
(the E light turns on) and it is ready for
cutting. To stop, switch the D switch
downwards.
Use of the appliance
with mains power supply (Fig.4)
Choose the cutting size according to in-
structions of fig. 6.
Insert the small socket L of the small adap-
ter cable into the small lower socket L,
then insert the plug G of the adapter in
a suitable mains socket, (the E light turns
on).
Grab the shell of the appliance A, push the
D switch upwards (the E light turns on) and
it is ready for cutting. To stop, switch the
D switch downwards. After this operation,
disconnect the G plug from the mains po-
wer supply.
Cutting adjustment size
To change the cutting size with an assem-
bled spacer, rotate the C guide.
Start
After choosing the type of power supply
and adjusting the cutting size, to turn the
appliance on, push the D switch upwards
(the E light turns on). To turn it off, switch
the D switch downwards.
Cleaning and maintenance
Never wet the appliance and its electric
components.
For cleaning, use only a cloth, slightly wet
with water or a solution with delicate soap
and dry it thoroughly.For the cleaning of
blades, use the R brush provided
ATTENTION
The incorpored batter contains substan-
ces, which may damage the environment.
When getting rid of the appliance, address
to a collection and disposal centre,in com-
pliance with the environmental regulations
in force.
