OG3:9
RT655 Operator’s Guide
Johnston Sweepers Limited
Chapter - Operation
Page Issue A
To Tip the Load
Open the rear door by pressing DD-A and F.
Raise the body by pressing switch DD-C and F, this will cause the body prop ‘A’ (painted red) to
index into the locking step ‘B’ on the subframe. Ensure the prop has located against the step.
After the load discharge and whilst the body is raised, wash out the intake tube, filter screen (Item
15, Fig.1), SepaVac unit (Item 18, Fig.1) and the rear door with the washdown hose or Supawash
hand lance (whichever is fitted) to remove any ‘caked’ material.
(B)
(A)
RTOG. 009-5
(C)
A bang should be heard when the rear door locking pin locates in the latch plate.
A warning light (B7) on the switch panel illuminates and a bleeper will sound when the
body is raised or not fully lowered.
To Lower the Body
Ensure that the chassis air system is fully charged so the body prop delatch system will operate
correctly and prevent any possible damage to the release mechanism.
Press DD-C and F to raise the body so that the body prop can clear the locking steps.
Press buttons DD-D, E and F to lower the body.
Press button DD-B and F to close the rear door.
