11
12
7. Connect the tether hook securely to the anchorage fitting.
17
!
Use top tether for installation if vehicle is equipped with a tether
anchorage fitting and vehicle requirements are met (see vehicle
owner’s manual).
8. Make sure that tether hook are securely attached to the anchorage
fitting.
18
The colors of the indicators on tether strap adjuster should
be completely green.
9. The child restraint system is installed as shown in
19
.
!
The colors of the indicators on tether strap adjuster should be
completely green.
19
-1
!
The colors of the indicators on both ISOFIX connectors should be
completely green.
19
-2
Removing the enhanced child restraint
1. Press the release button
20
to loosen the webbing and then detach
the hook to remove the top tether.
21
2. To remove base from the vehicle, press the ISOFIX release button
and pull the base back from the seat.
22
3. Then press and pull back on the ISOFIX connector on both sides.
23
4. For transporting, press ISOFIX release button and move back ISOFIX
connector so it is folded completely.
24
Securing your Child
1. Press the webbing adjustment button, while pulling out the shoulder
harnesses to the proper length.
25
2. Press the red button to disengage the buckle.
26
3. Fix the buckles on the both sides of seat to make placing the baby
more convenient.
27
4. Please use the infant insert to support the child if the child shoulders
is lower than the headrest bottom edge.
28
5. Place the child into the enhanced child restraint and pass both arms
through the harnesses.
29
6. Engage the buckle.
30
7. Pull down the adjustment webbing and adjust it to the proper length
so that your child is snugly secured.
31
!
Make sure the space between the child and the shoulder harness is
about the thickness of one hand.
8. Be able to fix the webbing under the soft goods.
32
Using in the Junior Mode
(Child height 100cm-150cm/Child weight
15kg-36kg/3 years - 12 years old)
see images
33
-
38
1. Store the shoulder strap cover, crotch belt cover in a safe place.
33
2. Store the buckle and harness straps in a safe place.
34
35
36
Securing your Child
For installation with 3-point-belt
1. To ensure the head support is at the correct height the bottom of the
headrest MUST be even with the top of child’s shoulders.
2. Correctly assembled 3-point-belt is shown as
37
!
Shoulder belt must pass through shoulder belt guide.
37
-1
!
Waist belt must pass through waist belt slots.
37
-2
!
The enhanced child restraint can not be used if the vehicle safety
belt buckle (female buckle end) is too long to anchor the enhanced
child restraint securely.
37
-3
