Handheld Optical Light Source-JW3116
10
5.4 Output Power
Notice: Preheating is normally required to ensure a stable output power for
the laser source. Normally less than 15 minutes would be okay.
5.4.1 Open the dust cap, connect with the patch cord.
Notice: Make sure the connector and the end-face of the patch cord is clean, and take
notice on the type of the patch cord, make sure the correct patch cord are connected.
5.4.2 Laser on the light source.
When open JW3116, the laser source still laser off, only after press
or
can
laser on the diode (5-8 & 5-9)
Laser off
5-8 Press
to laser on the diode
Laser off
5-9 press
to laser on the diode
Notice: To avoid risk of serious eye damage, Do not look into the interfaces
at any time.
5.4.3
Select the wavelength
Laser on(output wavelength 1310nm,
rated output power-5.00dBm
，
270Hz
frequency0Hz means do not load the
frequency
Laser on(output wavelength 1310nm, rated
output power-5.00dBm
，
0Hz means do not
load the frequency
