Surface Technology
Oberflächentechnik
5
5
6
7
1
2
3
4
5
Figure 5.1 Symbol drawing hand-filling machine
Operation / Use / Care
Setting the DIPROFIL
®
hand-filing machine FPT/ER and FPV/ER into operation
1.
Loosen the tool retaining screw (5.1/3) and tighten it firmly again after inserting the tool.
The guide ring (5.1/2) can be detached from the machine housing after loosening the
setscrew (5.1/6), so that the tool can be freely guided.
Pushing back the guide ring and tightening the screw in turn creates a rigid connection
with the machine housing.
2.
Screw the micromotors J-BM 40, J-BM 50 or J-BM 50HT into the mounting thread on
the underside of the hand-filing machine. The connection must be achieved without
major resistance. Otherwise, the appropriate position is obtained by slightly rotating the
eccentric cam (5.1/5).
„P“ - measuring point for vibration measurements
Only use authorised tools according to the joke catalogue!
Clamping screw
Guide ring
Tool holder screw
Protective hood
Eccentric cam shaft
Setscrew
Locking screw
