Jole gemm, Instruction Manual

33

34

Securing Child

in the Infant child 

restraint

1. While pressing the adjustment button located at the front of  

   the infant child restraint, pull completely the two shoulder    

   harnesses of the infant child restraint. 

(Fig. 14)

2. Unlock the buckle of the harnesses by pressing the red  

   button. 

(Fig. 15)

3. There are 2 positions crotch harness adjusted according to   

   different requirements.
  

Position 1 

Smaller babies use this position 

(Fig.16.1)

Position 2 

Larger babies use this position 

(Fig.16.2)

!

Suggest heavier than 10kg babies use position 2.

i.  Pull the crotch harness out and place it to be level. 

(Fig.17.1&Fig.17.2&Fig.17.3)

ii.      Rotate the crotch harness anchor to make the short side    

        forwards,  then thread it through the crotch harness slot.

(Fig.17.4)

iii. Rethread it through the slot that is closest to child's  

        crotch from the front of the crotch harness. 

(Fig. 16)

4. Place child into theinfant child restraint and lock the buckle.  

(Fig. 18)

5.  Tension the shoulder harnesses by pulling adjustment  

   webbing. 

(Fig. 19)

!

Make sure the space between the child and the shoulder    

    harnesses is about the thickness of one hand.

1.  Insert is for infant's protection.

Infant insert must be  

     used for children 0-6 months.
2.  Before using the insert, please assemble foam.

(Fig. 13)

3.  After child is placed into the seat, check whether the  

     shoulder harnesses are at proper height.

(Fig

. 7)

Note

Infant Child Restraint 

Installation

The infant child restraint can be used with the joie base and 

certain joie strollers. The installation instructions vary depending 

on whether or not you are using the base or stroller. Please refer 

to the proper section.

!

Do not place the infant child restraint on vehicle seat with    

  airbag. Death or serious injury can occur.

(Fig. 20) 

!

When use the infant child restraint in a vehicle seat, please    

  adjust the handle to position 1.

(Fig. 5.1) 

!

Face your infant child restraint or base toward the rear of the  

 vehicle.

!

Ensure the vehicle safety belt is not slack or twisted.

!

  Always fasten the harness of your infant child restraint  

  securely on your infant, regardless of how it is being used.

i. Installing without Base

After fitting the harness to your child and determining which rear 

vehicle seat location is best, you are ready to install your infant 

child restraint. 
1. Place the infant child restraint onto the vehicle seat where    

  you wish to put it. Pull the vehicle safety belt out and lock it   

  into the vehicle buckle, sliding the vehicle lap belt into the    

  side guides of the infant child restraint. 

(Fig. 21)

!

  The infant child restraint can not be used if the vehicle  

    safety belt with female buckle is too long to tie the infant    

  child 

restraint. 

(Fig. 21.1)

2. Slide diagonal belt into the rear guide. 

(Fig. 22) 

3. Pull the belt to fasten the infant child restraint tightly and  

 securely. 

(Fig. 23)

!

  Tension the vehicle safety belt as much as possible,  

    check that it is not loose or twisted.