Jole gemm, Instruction Manual

35

36

!

  The vehicle safety belt shall not cause pressure on any    

    part of the child.
Correctly assembled vehicle safety belt is shown as

 Fig. 24

!

  Lap belt must pass through the two side guides,   

     as

Fig. 24.1

!

  The vehicle buckle is locked correctly, as

Fig. 24.2

!

  Diagonal belt must pass through the rear guide,    

     as

Fig. 24.3

ii. Installing with Stroller

Your infant child restraint is designed to attached to certain joie 

stroller models featuring a special tray, armbar or calf support.
The stroller models include, but not limited to the following: 

all muze, extoura, brisk, kixx, litetrax, krome models, a part of 

aire, mirus models.    

!

  Please make sure your stroller can fit the infant child restraint  

  before purchasing it. 

!

  Never allow more than one baby in the travel system                   

   at one time.

!

  Please brake your stroller before assembling the infant child   

 restraint.

!

  Check the parts that are used to fix the infant child restraint   

  are securely fastened on the stroller. 

!

  Recline the stroller seat back to the lowest position.

To assembling the infant child restraint on Joie strollers, please 

follow these steps:
1. Place infant child restraint into stroller so notches in rockers  

   fit over edge of armbar, tray or calf support. The infant child  

   restraint will then automatically click into place.                

(Fig. 25 & 26 & 27 & 28)

!

  If armbar has fabric cover, please detach the velcros on    

    armbar cover first. 

(Fig. 27.1)

!

  For the stroller with a special calf support, please adjust    

    the calf support to the vertical position, detach the  

    velcros, and then lift the fabric cover.

(Fig. 28.1)

2. Using the straps on both sides of stroller to fix the infant  

  child restraint.

 ( Fig. 29 & 30 & 31)

!

  Try pulling the infant child restraint upwards to check that   

    it is fitted correctly.

To remove the infant child restraint

, release the straps from 

the infant child restraint, pull up the stroller fix release handle to 

release the infant child restraint from tray, armbar or calf 

support, and then lift infant child restraint out of stroller, please 

refer to 

(Fig. 32 & 33 & 34)

!

  If you have any problems about using these strollers,  

  please refer to their own instruction manuals.

Detaching Canopy and  

Seat Pad

To detach the canopy,

 while pressing the button in the 

canopy mount, pull the canopy bow out. 

(Fig. 35)

To detach the seat pad, 

you should refer to the following 

steps: 
1.  You must remove the insert first. To do this simply unlock    

  the buckle, then unclip the snaps on both sides of the  

  insert and pull out away from the seat. 
2.  To remove the crotch pad, first locate the elastic on the  

  inside of the crotch pad. Pull both the elastic and the crotch  

  pad over the buckle to remove. 

(Fig. 36)