Fixture installation meth：
①frame ②clip ③ M8 bolt ④mounting rail
④
②
③
①
5.2 Mechanical installation and
precautions
5.3 Framed Bifacial Double-Glass
Modules (installation with clamps)
Modules could be mounted with clamps
or bezels. Modules Installation must be
carried out according to the following
examples and recommendations. If the
installation method is d i ff e r e n t f r o m
below methods, please consult Jolywood
local technical support or after-sales, to
obtain the consent of Jolywood, otherwise
when the modules is damaged, the limit
warranty would be invalid.
The mechanical load of the module
(including snow and wind loads) depends
o n t h e w a y o f m o d u l e i n sta l l e d . T h e
mechanical load should be calculated
by the professional s y st e m d e s i g n e r
b a s e d o n a c t u a l c o n d i t i o n s a n d en-
v i r o n m e n t a l . M o r e o v e r, i t d o e s n o t
withstand the excessive force generated
by the thermal expansion of the support
structure. The drain hole should not be
blocked under any conditions during
installation or use.
Edge Clamp& Middle Clamp:
9
Jolywood (Taizhou) Solar Technology Co.,Ltd.
Kaiyang Rd., Jiangyan Economic Development zone, Taizhou City, Jiangsu Province, P. R. China
www.jolywood.cn
mkt@jolywood.cn
+86-523-8061 2361
Mounted with 4 clamps along the long frame.
A=350mm±30mm.
C-shaped steel parallel to the long frame.
Clamp: height=30mm,width=40-50mm.
Maximum load: front ≤2400pa back ≤2400pa.
Mounted with 4 clamps along the long frame.
A=350mm±30mm.
C-shaped steel perpendicular to the long frame.
Clamp: height=30mm,width=40-50mm.
Maximum load: front ≤5400pa back ≤2400pa.
Installation Manual
- Jolywood N-type Mono-crystalline Double Glass Module
①
③
④
②
