XBASE 999 Operating Manual
79
Filter Routing (8)
With
(Shift)
+
(Step 8)
you are entering the filter routing menu.
The display shows the following:
Filter Routing PerfOO1
x^x^^^^xx Stereo ShifOO8
With the
(Data)
encoder you can select the following cross filter
modes:
<Stereo>
Stereo
Both filters run independently.
<Parall>
Parallel
Both filter outputs are mixed together...good for
multipeak filters.
<Serial>
Serial
The signal first passes the left and then goes into the
right filter.
<Fedback>
Feedback
The outputs of each filter are cross feedbacked into the
input of the other filter, but the outputs are stereo (not
mixed). Hear the harsh resonant and distorting filter
peaks, especially when modes (i.e. LP / HP) are
different on both filters.
<FedbPar>
Feedback parallel
The outputs of each filter are cross feedbacked into the
input of the other filter, and the outputs are mixed.
This generates the most distorted and crying feedbacks
or extreme filter slopes.
By the
(Instrument)
keys you can decide which instruments are
routed into the filter.
