13
OPERATION
Fig. 15
RESETTING IGNITION SYSTEM PASSCODE
(See Fig. 15)
The SmartSwitch Ignition is preset at the factory with the
default code "321". To reset or change the passcode, the
operator does not have to be seated on the tractor.
1. Press the SmartSwitch Ignition (SSI) button (F) once (or
sit on the seat). Ensure the indicator is blinking blue.
2. Press and hold the (1) and (3) buttons simultaneously
for approximately three (3) seconds until the SSI button
changes to solid blue.
3. Using the numbered buttons, enter the desired pass-
code. The passcode may be anywhere from one to
five digits in length.
4. After the desired passcode has been entered, press
the SSI button (F) once.
NOTE:
When the indicator flashes green, the passcode has
been accepted. If the indicator blinks red, the passcode has
not been accepted. Wait until the indicator returns to blink-
ing blue and repeat this procedure starting from step two.
F
TO START ENGINE
NOTE:
The default passcode "321" is preset at the factory
and should be changed prior to first use. (See "RESET-
TING IGNITION SYSTEM PASSCODE" in this section of
the manual.)
S
MART
S
WITCH
WARNING LIGHTS (See Fig. 16)
The SmartSwitch Ignition is programmed with warning lights
to indicate when any part of the safety system is not being
followed. The engine will not start until all the following
ignition system faults are resolved:
• The park brake symbol (CC) will be lit if the parking
brake has not been engaged during a start attempt.
•
The blade switch symbol (EE) will blink if the attachment
clutch control is not in the "DISENGAGED" position
during a start attempt.
Fig. 16
PRE-START
•
Ensure freewheel control is in the transmission en gaged
position.
• Ensure transmission is in the neutral position
•
Move attachment clutch control to the “DISENGAGED”
position.
• Sit on seat in operating position, depress brake pedal
and set parking brake.
S
MART
S
WITCH
IGNITION UNLOCK
1. Press the SmartSwitch Ignition (SSI) button (F) once (or
sit on the seat). Ensure the indicator is blinking blue.
2. Enter passcode and press the SSI button. If passcode
is not accepted, the SSI button will blink red. Wait until
the SSI button returns to blinking blue before attempting
to re-enter passcode. Once accepted, the SSI button
will flash green.
3. Ensure that the SmartSwitch Safety System warning
lights are not showing any faults present. If any warning
lights do indicate faults present, resolve those faults
before continuing with STARTING.
STARTING
The Briggs & Stratton Endurance engine equipped with
your tractor features a Ready-Start automatic choke system
to provide simplified starting in normal conditions. Please
read the following starting instruction carefully.
NOTE:
For the first time starting after your tractor has sat
for an extended period of time, or after running out of gas,
the engine may require an extended start attempt to reprime
the fuel system. For an extended start, press and hold
SSI button for three seconds before releasing. This will
prompt the engine to attempt starting for up to ten seconds
(instead of the normal five seconds), allowing time for fuel
to be pulled into the engine.
F
CC
EE
