Jonsered LT2220 CMA2, Operator'S Manual

22

SERVICE AND ADJUSTMENTS

TRACTOR

TO REMOVE MOWER (See Fig. 25)

Mower will be eas i er to re move from the right side of trac-

 tor.
•  Place attachment clutch control in “DISENGAGED” 

po si tion.

•  Move attachment lift lever forward to lower mower to 

its lowest position.

•  Roll belt off clutch pulley.
•  Disconnect anti-sway bar from chassis bracket by 

re mov ing re tain er spring.

•  Disconnect suspension arms from rear deck brackets 

by removing retainer springs.

•  Disconnect front links from deck by removing retainer 

springs.

•  Raise lift lever to raise suspension arms. Slide mower 

out from under tractor.

IMPORTANT:

  IF AN ATTACHMENT OTHER THAN THE MOWER 

DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE 

FRONT LINKS.

TO INSTALL MOWER (See Fig. 25)

Be sure tractor is on level surface and mower suspension 

arms are raised with attachment lift control. Engage park-

 ing brake.
•  Slide mower under tractor.

IMPORTANT:

 Check belt for proper routing in all mower 

pulley grooves.
•  Install belt into clutch pulley groove.
• 

Install left front link into the left hand front mower bracket 

(retain with single loop retainer springs as shown).

• 

Slide right side of mower back and install right front link 

into right hand front mower bracket (retain with single 

loop retainer springs).

• 

Place the suspension arms on mower pins, if nec es sary, 

rock and raise front of mower to align mower pins with 

the holes in suspension arms. Retain with double loop 

retainer spring, loop down as shown.

•  Connect anti-sway bar to chassis bracket under left 

footrest and retain with double loop retainer spring.

•  Raise deck to highest position.

Fig. 25

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS:

•   Depress clutch/brake pedal fully and set parking brake.
•   Place motion control lever in neutral (N) position.
•   Place attachment clutch  in “DISENGAGED” position.
•   Turn ignition key  to “STOP” and remove key.
•   Make sure the blades and all moving parts have completely stopped.
•   Disconnect spark plug wire from spark plug and place wire where it cannot come in contact  

 with 

plug.

ANTI SWAY 

BAR

RETAINER 

SPRING

RETAINER 

SPRING

SUSPENTION 

ARMS

CLUTCH PULLEY

FRONT LINKS

RETAINER 

SPRINGS