Jonsered LT2220 CMA2, Operator'S Manual

6

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  

To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 

the correct tools as necessary to ensure proper tightness.

ATTACH STEERING WHEEL (See Fig. 2)

•  Remove locknut and large flat wash er from steering 

shaft.

• 

Position front wheels of the tractor so they are pointing 

straight forward.

•  Slide the steering sleeve over the steering shaft.
•  Position steering wheel so cross bars are horizontal 

(left to right) and slide onto steering wheel adapter.

•  Secure steering wheel to steering shaft with locknut 

and large flat wash er pre vi ous ly removed.  Tight en 

securely.

•  Snap steering wheel insert into cen ter of steering 

wheel.

•  Remove protective materials from tractor hood and 

grill.

IMPORTANT:

 CHECK FOR AND REMOVE ANY STAPLES IN 

SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO 

ROLL OFF SKID.

Fig. 2

04000

STEERING WHEEL CAP

LOCK NUT

LARGE FLAT WASHER

STEERING 

WHEEL

STEERING SHAFT

STEERING 

WHEEL 

ADAPTOR

STEERING BOOT

TO CHECK BATTERY (See Fig. 1)

OPEN BATTERY COVER FOR:
• 

Inspection for secure connections (to tighten hardware).

•  Inspection for corrosion.
• Testing 

battery.

•  Jumping (if required).
•  Periodic charging .

NOTE:

 If this battery is put into service after month and 

year indicated on label (label is located between terminals) 

charge battery for minimum of one hour at 6-10 amps. 

(See "BATTERY" in Maintenance  section of this manual 

for charging instructions).
•  For battery and battery cable installation see " RE-

PLACING BATTERY" in the "Service and Adjustments" 

section in this manual.

Fig. 1

BATTERY 

COVER

LABEL

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier.  Stan dard 

wrench sizes are listed.
(1)  5/16" wrench 

Utility knife

(2)  7/16" wrenches 

Tire pressure gauge

(2) 1/2" wrenches 

Pliers

(2)  9/16" wrench 

Phillips screwdriver

When right or left hand is mentioned in this man ual, it means 

when you are in the operating po si tion (seated be hind the 

steer ing wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

•  Remove all accessible loose parts and parts cartons  

from carton .

•  Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels flat.

•  Check for any additional loose parts or cartons and 

remove.

BEFORE REMOVING TRACTOR FROM 

SKID