Room² Instruction Manual
Unpacking/Assembling the Playard
• Keep children away from playard while unpacking.
• Open the travel bag and remove the playard and mattress.
• Release each of the Velcro® straps and slide them through the plastic ring as
shown. See Figure 2.
• Set the mattress aside and orient the playard so it is resting on the feet and
wheels.
• DO NOT push the center down yet.
• With the center of the playard up, pull upward on each side rail until it locks into
position. You will hear the rails lock into place. See Figure 3
NOTE: There is ONE mechanism that locks BOTH pieces of tubing on EACH side
rail. See Figure 4.
• Make sure that the top rails have become rigid. If they haven’t, pull up again until
they are rigid. You may need to lift the center of the floor higher.
• Once you have locked the side rails in the up position, go back and check each
side rail again to be sure they are all locked into position.
• Hold one side of the playard up and push down the center of the floor. See Figure 5.
• Set the mattress inside the playard with the soft side up. See Figure 6.
• Locate the Velcro® straps near the corners of the mattress.
• Slide a strap through the slot in the floor of the playard and secure it to the
underside of the playard. See Figure 7. Repeat this step on the other three corners.
!
WARNING
Be careful not to pinch your fingers on the top corners during assembly.
ALWAYS ensure that all side rails are locked into position before using this
product. ALWAYS secure the mattress to the playard floor with the Velcro®
straps. NEVER use items not recommended by Joovy with this product.
Figure 3
Figure 2
Page 3
Page 4
