Caboose Ultralight Instruction Manual
EN
10 Securing the Front Seated Child
• There are three height adjustment positions for the shoulder harness. Adjust the height to the closest height above your child’s shoulders.
• To remove the shoulder harness, turn the plastic ends sideways and push them through the slots in the seatback. Reattach the harness at
the proper height by reinserting the plastic ends through the slots. See Figure 10.1. Ensure both straps are the same height.
• To remove the crotch strap, slide the strap through the small opening in the metal D-ring. Reattach by pushing the metal-D ring through the
slot in the seat, wrap the strap around the tube under the seat bottom. Slide the strap through the small opening of the metal D-Ring and
pull the strap to secure it to the tube. See Figure 10.2.
• Remove the waist straps by sliding the strap through the small opening in the metal D-ring, then pull the strap away from the seat.
See Figure 10.3. Reattach by pushing the metal-D ring through the slot in the seat, wrap the strap around the seat back frame tube. Slide
the strap through the small opening of the metal D-Ring and pull the strap to secure it to the tube. Repeat for the other end of the strap.
• To unlatch the buckle press the center button and remove the male ends of each buckle. See Figure 10.4.
• To separate the shoulder harness from the waist harness, simply slide the waist buckles from the shoulder buckles. See Figure 10.5.
• Carefully place the child in the seat with the shoulder straps over their shoulders and chest. Then place the crotch strap between the child’s
legs.
• Bring the waist straps around the child’s waist and insert the male ends of the waist buckles into the shoulder buckles. See Figure 10.6.
Then push the shoulder/waist latch posts into the crotch buckle until all parts snap into place. See Figure 10.7.
• Tighten the waist belt to be snug around the child’s waist.
• The shoulder, waist, and crotch straps may be adjusted using the sliding plastic rings on these straps.
12 Using the Stand-On Platform
• Push the bench seat to its most forward position.
• Position the canopy to its most forward position.
• Position the child on the platform on the back of the stroller. Be sure that the child is facing forward and BOTH of their hands are holding the
handles on the frame.
• Be sure that BOTH of the child’s feet are fully on the platform at all times.
• You may need to adjust the recline position of the seat to allow for more room for the child to stand.
11 Seat Recline Positioning
The front seat has 3 recline positions. This seat should only be used for a child that is at least 3 months old. For children between 3 and 6
months, only use the fully reclined position.
• To place the seat in the first upright position, squeeze the recline bars located on the back of the seat, and move the seat to the upright
position. Check to ensure that the recline mechanism has engaged and the seat does not move. See Figure 11.1.
• To recline the seat, squeeze the recline bars and move the seat to either the second (middle) or third recline positions. Again, check to
ensure that the recline mechanism has engaged, and that the seat does not move.
!
WARNING
The front seat is not suitable for children under 3 months. Avoid serious injury from falling or sliding out.
Always use the restraint system.
!
WARNING
Whether the seatback is upright or reclined, ALWAYS make certain that the recline mechanism is
engaged before placing the child into the seat.
!
WARNING
The rear stand-on platform and the rear bench seat are designed for a child that is at least 2-1/2 years old but LESS than 44 inches tall and
less than 45 lbs.
Use of the stroller with two children weighing more than 45 pounds each, or children totaling more than 90 pounds, will cause excessive wear
and stress on the stroller and may cause a hazardous unstable condition.
NEVER allow a standing child to use the canopy as a hand hold.
NEVER use this stroller to carry more than 2 children at the same time.
9 Adjusting the Footrest
The footrest can be adjusted fully up or down.
• To lock the footrest upright, pull up on the footrest and lift up on the support bar. Ensure it is locked in place. See Figure 9.1.
• To put the footrest into the down position, pull up on the footrest, push down on the support bar, then release the footrest. See Figure 9.2.
!
WARNING
Never allow a child to step onto the footrest in either position in order to get into or out of the stroller. This may cause the stroller to tip over
and injure the child.
