EN
EN
13 Using the Rear Bench Seat
• Push the bench seat to its most rearward position.
NOTE: There are webbing straps attached to the bottom of the rear seat pad. These straps will lock the seat into the most rearward position.
To lock the seat, pull the straps from EACH side of the pad and loop them around the frame as shown, then snap them together.
See Figure 13.1.
• To slide the seat forward, undo EACH snap and reattach the webbing to the underside of the seat pad using the Velcro® attachments.
• Position the canopy to its most forward position.
• To unlatch the buckle press the center button and remove both latch posts.
• Have the child sit on the bench seat facing backward with their feet on the platform.
• You may need to adjust the recline position of the seat to allow for more room for the child to sit.
• Place the crotch strap between the child’s legs.
• Push the waist latch posts into the crotch buckle until all parts snap into place. See Figure 13.2.
• Adjust the seat belt to be snug around the child’s waist.
• Be sure that BOTH of the child’s feet are fully on the platform at all times.
• Be sure that BOTH of the child’s hands are holding the handles on the frame.
14 Storage Basket
The maximum weight that can be carried in the storage basket is 5 lbs
.
!
WARNING
NEVER allow a rear seated child to use the canopy as a hand hold.
15 Folding the Stroller
• Keep children away from stroller while folding.
• Remove any infant car seat. The stroller can be folded with the infant car seat adapter in place.
• Close the canopy and push it forward.
• Put the front seat into the most upright position.
• Make sure both rear wheel brakes are set to their locked positions.
• Lock BOTH front wheel sets in place with locking levers facing forward.
• Unlock the safety latch on the lower left side of the stroller.
• Pull upward on the trigger mechanisms on both sides of the stroller and push the handle fully forward. See Figure 15.1.
CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
• Engage the fold lock on the right side of the stroller over the mounting post. See Figure 15.2.
!
WARNING
ALWAYS keep children away from the stroller when folding.
Possible pinching hazard - Be careful when folding the stroller.
16 Using the Stroller with an Infant Car Seat (OPTIONAL)
NOTE: See insert for a list of specific compatible car seat models.
• Remove the front tray and install the infant car seat adapter on the same mounts. Ensure it is secure on BOTH sides. See Figure 16.1.
• Push the canopy to its most rearward position.
• ADJUST THE SEAT TO ITS SECOND (MIDDLE) POSITION.
• Remove the infant car seat from its base and place it onto the front seat of the stroller so it is in a REAR FACING POSITION. Position the
“head” end toward the front, resting on the infant car seat adapter. Position the “feet” end on the seatback - but NOT on the top edge of the
seatback. See Figure 16.2.
• Buckle the
red
restraining straps over the LOWEST part of the infant car seat (the straps are located in the pockets on the side of the seat)
Adjust the straps so they are tight around the infant car seat but AWAY from the child’s neck. Pull up on the infant car seat to be sure it is
secure. See Figure 16.3.
• To remove the infant car seat from the stroller, unlock the restraining strap buckle by pressing the button and both side releases.
See Figure 16.4.
• Return the restraining straps to their pockets.
!
WARNING
ALWAYS install the infant car seat so that the child is facing toward the rear (handle) of the stroller with the restraining straps secured.
ALWAYS position the infant car seat so that it is securely placed down inside the infant car seat adapter frame.
ALWAYS position the infant car seat so that it is resting ON the seatback, but NOT on the top of the seatback. The seatback must be in the
second (middle) position.
NEVER position the restraining straps on or near the child’s neck as this may result in strangulation.
The infant car seat adapter is for use ONLY with specific infant car seat models. See insert for specific models. DO NOT use other infant car
seat models.
