4
INSTALLATION INSTRUCTIONS
IMPORTANT NOTICE
Before installing this product, make sure it
complies with your request and that it suits
your application!
1. Unpack the unit and visually inspect for any
transport damage incurred after leaving our
factory.
2. Depressurise the system before installation or maintenance is carried out!
3. The drain is shipped fully assembled!
Disassemble the drain before installation by
unscrewing the screw in the connector and the
top nut above the coil (see page 3 for an
exploded view).
4.
Locate a suitable condensate draining point
on your compressor system and connect your
valve as illustrated below. Connect the outlet to
an oil/ water separator. We recommend using a
JORC condensate cleaner.
-
Make sure the arrow on the valve body
complies with the flow direction of the
condensate.
-
Do not use valve shaft as lever!
