8
FIG.1
ASSEMBLY INSTRUCTION
1.PREPARATION:
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the
above of this instruction sheet you will find an explosion drawing with all single parts
(marked with numbers) which this item consists of.
2.ASSEMBLY INSTRUCTION:
:
FIG.2
FIG.2:
Insert the Vertical Seat Post (pt.10) into
the seat post tube of the Main Frame.
You will have to slacken the Knob (pt.65)
and pull the knob back. Then select the
desired height. Release the knob and
retighten the knob.
The Seat (pt.74) is fixed on the Seat
Post (pt.11) .
FIG.1:
Attach the Front Stabilizer (pt.8) to the
Main Frame (pt.1) with two sets of Ø8
Flat Washer (pt.58), M8 Domed Nut
(pt.40) and M8*57 Carriage Bolt
(pt.46).
Attach the Rear Stabilizer (pt.9) to the
Main Frame (pt.1) with two sets of Ø8
Flat Washer (pt.58), M8 Domed Nut
(pt.40) and M8*57 Carriage Bolt
Summary of Contents for JOROTO-X2
